Hotline: +49 (0)7227 994255-0
E-Mail: 
Tool Length Sensor Sorotec WLS 2 (14 mm)
Tool Length Sensor Sorotec WLS 2 (14 mm)
| 8 or 14 mm: Which WLS do I need? |
| With a small machine table, every square inch of clamping surface often counts. In most cases, smaller milling cutters up to max. Ø 6 mm are used here. Then the small tool length sensor is recommended. However, larger milling cutters also require a larger sensor probe. Since the cutting edges to be measured are on the outside of the radius, they would sink past a button that is too small. Here it must be the 14 mm variant. |
The micro switch inside is mounted on a spring. If the Z-Axis does not stop in time or your ramps are too long, the switch does not get damaged. It can be pressed 4 mm into the spring. The switch is configured as normally closed, but can be reconfiguerd very easily to normally open contact. Completely detachable over a central screw.
Techncal Specifications:
- Height: 41.5 mm
- Diameter: 40 mm
- Diameter of switch head: 14 mm
- Material: Housing: Alu, Sensor: Chromed brass
- Cable length: ca. 3 m
Delivery without connection plug.
Datasheet WLS 2 (german)Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |
