Hotline: +49 (0)7227 994255-0
E-Mail: 
Cleaning system for Tool Length Sensors Sorotec WLS 2
NEW
Cleaning system for Tool Length Sensor Sorotec WLS 2 (14 mm)
In order to prevent falsification by chips, the sensor surface should be wiped or blown briefly before each measurement. However, especially with large CNC machines, the tool length sensor is often difficult to reach by hand. The cleaning nozzle solves the problem in a very elegant way.The nozzle is mounted on the grooved plate together with the tool length sensor and supplied with compressed air via either a manual valve or an electric pneumatic valve and a release button. The operation can therefore be done conveniently from the front of the machine or elsewhere besides. The air then flows out of the nozzle at the upper end directly onto the sensor surface and safely blows chips and other disruptive particles to the side.
If the cleaning process is to be automated, this requires a separate control output and a corresponding programming change.
Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |
