Hotline: +49 (0)7227 994255-0
E-Mail: 
JMC Closed Loop Integrated Stepper Motor
IHSS86-60-45 | 4,5 | NEMA 34
Length of shaft: 38 ± 1 mm
Shaft diameter: 14 mm Center diameter: 73 mm Hole spacing NEMA 34: 69.8 mm |
Precise, quiet, reliable
The IHSS86-60-45 combines the strengths of stepper and servo drives in a space-saving, complete system. The integrated power amplifier significantly reduces hardware and controller setup requirements. In closed-loop operation, a high-resolution encoder with a 50 μs sampling rate detects even the smallest position deviations and compensates for them immediately, thus eliminating true step losses. The microsteps are defined once directly on the motor using DIP switches.
Compared to other solutions, the quiet running is astonishing, not only at high speeds. Even during otherwise rough slow running, as well as during acceleration and deceleration, the integrated JMCs behave exceptionally quietly and smoothly.
Technical Data:
Step angle (Resolution): 1.8°
Max. Microsteps: 51200
Min. Microsteps: 200
Operating voltage: 24 ... 80 V DC
Rated current (current per winding): 6 A
Datasheet (german)
JMC-Software Closed LoopManufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |
