Hotline: +49 (0)7227 994255-0
E-Mail: 
1207HO | Solid carbide end mill Z2 UP/DOWN Ø 4 mm wood
1207HO | Solid carbide end mill Z2 UP/DOWN Ø 5 mm wood
Cuts top and bottom without tearing
At the bottom, on the cutting edges, this cutter is spiraled to the right. In the upper part, the spiral runs anti-clockwise. This means that the thrust goes inwards on both sides of the material, and the top and bottom remain smooth and without frayed tears.
Technical Specifications:
- D2 (Shank): 5 mm
- SL (spiral lenght): 26 mm
- UL (lower spiral length): 6 mm
- GL (overall length): 60 mm
- Solid carbide two-edge cutter with clean cut
- Good chip removal thanks to wide spiral
Applications:
- very suitable for wood materials
- suitable for plastics
- Perfect for everything veneered: plywood, multiplex, blockboard ...
Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |