Hotline: +49 (0)7227 994255-0
E-Mail: 
Tool changer V03 for AMB FME-1 1050 | AMB FME 800
incl. 2x toolholder
This spindle is suitable for the Kress FME 1050-1 and FME 800 (Does not fit 1050 FME-P).
The assembly is quick and very simple. It is screwed onto the spindle shaft and attached to the spindle. Then you can fasten the "tool change spindle" just like the original Kress with the Euro 43 mm mount.
Function:
The tool sits in a SK tool holder (in a ER11 collet). The SK15 Holder is held with spring force in the cone. A pneumatic cylinder (air port 1) presses the tool holder out of the cone.
Specifications:
- Aluminum case 7075, hard-anodized
- Stainless steel spindle
- Double ball bearings
- Concentricity of 0.01 mm
- Weight 0.9 kg
- Tensile force of the spring 25 kg
- Uses SK Toolholders for ER11 Collets (1 ... 8 mm)
- Operating pressure 8 bar
- 2 pneumatic connectors for 4 mm tubing
- Fastening with 43 mm mount
- Suitable for speeds up to 28.000 rpm
- Spindle is 55 mm longer through the tool changer
- Diameter of tool changer: 59 mm
Delivery Content:
Tool changer fitting Kress FME 1050-1 and FME 800 (Does not fit 1050 FME-P)
incl. 2 SK tool holders
quick installation manual
The shown collet and the spindle itself is not included.
To operate the tool changer you will need 1 Electro-pneumatic valves 3 / 2 to control the air
for switching.
Product Information from the manufacturer:
Please notice that our products are constructed only for the use in the field of hobby-milling / drilling / etc. or for the production of single parts or small serial production, but not for the use in the field of professional long-term usage or industrial production!
Operation Manual (german)Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |
