Hotline: +49 (0)7227 994255-0
E-Mail: 
ring end spanner, 5,5 mm
Description:
• From the series Slim-Line
• According to DIN 3110 and ISO 3318th
angled • Ring side by 15 °
• Clear size labeling facilitates finding the desired key length
• Handy, well in hand lying shaft with skin friendly surface (statin finish). No sharp edges or corners
• Polished chrome heads. Slim and thin-walled. For less problems in hard to reach nuts
• Although extremely thin and lightweight, the torques are much higher than required by DIN / ISO:
• Because for an optimal production of steel is used: chrome vanadium alloyed, drop forged, carefully hardened and tempered
• Because the tolerances are better than those required by DIN / ISO. Piece by piece is calibrated and final inspection
• Optimal surface protection against rust: 2x nickel, chrome 1 x
Dimensions:
• S1: 5.5mm
• B1: 9mm
• B2: 14mm
• L: 93mm
• H: 3mm~
• From the series Slim-Line
• According to DIN 3110 and ISO 3318th
angled • Ring side by 15 °
• Clear size labeling facilitates finding the desired key length
• Handy, well in hand lying shaft with skin friendly surface (statin finish). No sharp edges or corners
• Polished chrome heads. Slim and thin-walled. For less problems in hard to reach nuts
• Although extremely thin and lightweight, the torques are much higher than required by DIN / ISO:
• Because for an optimal production of steel is used: chrome vanadium alloyed, drop forged, carefully hardened and tempered
• Because the tolerances are better than those required by DIN / ISO. Piece by piece is calibrated and final inspection
• Optimal surface protection against rust: 2x nickel, chrome 1 x
Dimensions:
• S1: 5.5mm
• B1: 9mm
• B2: 14mm
• L: 93mm
• H: 3mm~
Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |