Hotline: +49 (0)7227 994255-0
E-Mail: 
Vacuum Table Eco 10050
Vacuum Table Eco 10050
Connection two-sided short side
When it comes to attaching flat workpieces quickly and easily for processing, vacuum tables are unbeatable: place the blank, switch on the vacuum, done - ideally, it is as quick and simple as it reads. So far, however, the comparatively high price has often spoken against use for hobby purposes. But that is changing now.This is made possible by the discovery that MDF panels are air-permeable. In a sandwich with a substructure with air channels, a workpiece support that offers suction over the entire surface is created - the holes you see in the photos are used for fastening with M6 x 12 cylinder head screws.
The vacuum table Eco comes with all attachments necessary for operation:
- Vacuum sandwich plate 1000 x 500 x 19 mm
- 2 perforated MDF panels
- 1 unperforated MDF panel
- 20 m PVC hose
- 4 adapters for 5 hoses each on HT pipe DN 40
- 1 HT pipe DN 40, length 15 cm
- 3 T-pieces HT DN 40
- 1 bend 87° HT DN 40
(The scope of delivery shown in the example image may vary.)
In most cases a normal vacuum cleaner is sufficient to create the vacuum.
DrawingManufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |