Hotline: +49 (0)7227 994255-0
E-Mail: 
PlasmaSensOut
| Support for PoKeys |
| Sorotec does not use any PoLabs products. Without our own experience, however, we lack the basis for competent advice. This is expressly not a rating! We do not sell products that we are not convinced of their quality. If you have any questions about the selection or troubleshooting, please contact the manufacturer directly (http://support.poscope.com/). |
is a universal torch height controller (THC) for using with the PlasmaSens – torch height sensor device. Thanks to an optical connection it’s fully electrically (galvanically) isolated from high voltage plasma cutter’s equipment and so it’s safe to use. PlasmaSensOut provides standard programmable ARC_OK, UP and DOWN signals and it’s compatible with most CNC controller boards on the market. A simple user-friendly interface allows quick and efficient moving through menu using three menu buttons. Led display in default state shows temporally arc voltage and led diodes signalize state of output. User can set the following THC parameters: reference voltage, hysteresis (non-active range around reference height), delay time and anti-dive limit voltage. All parameters are adjustable during operation.
Features- Output signals: Arc OK, Up and Down (DC solid state)
- Programmable reference and hysteresis voltage, delay time and anti-dive limit voltage
- Current plasma voltage presentation on LED display
- LED signalization of: Arc present, up and down
- Full optical input isolation; transmitter and receiver connected over an optical cable
- Test mode operation
- DC power supply (6 ... 36 V)
- Compatible with most CNC controller boards
- DIN-rail mountable housing
- PlasmaSensOut device
- PlasmaSens sensor device
- Optical cable (2 m and 5 m)
PlasmaSensOut User Manual (english)Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |