Hotline: +49 (0)7227 994255-0
E-Mail: 
Milling Motor Mafell FM 1000 NC-ER
For ER 16 collets. Only 71 dB by new air duct!
New version with new PV cable for greatly increased reliability.
Duo-In: The speed can be adjusted to any application, manually or via the gantry interface (0 ... 10 V).
Overload detector with LED status display, can also be evaluated externally via plug pin.
The FM 1000 is manufactured under strict quality control in Oberndorf am Neckar. Prior to delivery, each cutter is "run" under laboratory conditions.
This increases the service life and lifetime.
The speed can be adjusted to any application. In addition, the digital electronics are equipped with soft start, idle speed reduction, constant speed under load and overload protection.
The FM 1000 impresses with a high concentricity of < 0.05 mm at a distance of 25 mm (in the cone < 0.01 mm). Responsible for this extraordinary precision is the fine-tuning of all components and the fact that the anchor and spindle are manufactured from one piece and balanced.
The spindle can be locked at the push of a button for easy and convenient tool changing.
DOUBLE MOLDED SPINDLE
A closed double ball bearing is used to better absorb axial forces.
| Technical specifications: | |
| Rated current consumption: | 1000 Watt |
| Nominal idle speed: | 4.000 ... 25.000 rpm |
| Tension clamp: | 43 mm |
| Dimensions L x H x W: | 254 x 79 x 73 mm |
| Sound pressure level db (A): | < 71 |
| Weight: | 1.65 kg |
Scope of delivery:
- milling motor FM 1000 NC-ER (9M1401)
- collet ER16 diameter 8 mm
- clamping nut
- power cord 0.75 mm + 4 m
- wrench
Datasheet (german)
CAD fileManufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |