Hotline: +49 (0)7227 994255-0
E-Mail: 
MICROMOT- steel collet set
Triple slit and hardened.
With clamping nut and holder for storage.
1 each of 1.0 - 1.5 - 2.0 - 2.4, - 3.0 and 3.2mm.
For all handheld MICROMOT machines, excluding the Engraver GG 12.
Note:
MICROMOT steel collets are hardened and thus have a high, consistent flexibility. 1 They also maintain prolonged accuracy, even after regular use (these collets should not be compared with unhardened, fourslit collets of brass and aluminium). The triple slit collet is substantially more difficult to manufacture than the four-slit type, 2 but offers a better load-bearing surface. 3 This is especially important for cutters with small shaft diameters.
With clamping nut and holder for storage.
1 each of 1.0 - 1.5 - 2.0 - 2.4, - 3.0 and 3.2mm.
For all handheld MICROMOT machines, excluding the Engraver GG 12.
Note:
MICROMOT steel collets are hardened and thus have a high, consistent flexibility. 1 They also maintain prolonged accuracy, even after regular use (these collets should not be compared with unhardened, fourslit collets of brass and aluminium). The triple slit collet is substantially more difficult to manufacture than the four-slit type, 2 but offers a better load-bearing surface. 3 This is especially important for cutters with small shaft diameters.
Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |