Hotline: +49 (0)7227 994255-0
E-Mail: 
Interface board NetBob 1e with Network Interface
Interface board NetBob 1e with Network Interface
Interface board with CNC axis controller for the control of up to four stepper motor drives or servo controllers.Only for Beamicon2. Not compatible fot CNC control software Mach3 Software etc.
New: additional, fifth switching input. Even if all four axes are used, one input remains free, for example for use with a tool length sensor.
- Software inclusive
- Network interface instead of LPT port for reliable and interference-free data Transmission
- Integrated 32-bit microprocessor generates step / direction signals independently of the PC
- Robust real-time timing clock frequency to 1.6 MHz (all axes simultaneously)
- 4 RJ45 sockets for patch cables to UHU or Ethernet BEAST
- Also for brushless servos SanyoDenki suitable (with special cables K-BOBSD)
- 5 inputs for reference switches (mechanical or proximity), 1 emergency stop
- 2 relays for spindle and coolant Motor
- Analog output 0 ...10V for speed control (frequency converter)
- additional relay for holding brake (Z-axis)
- supports current reduction and status of signal amplifiers
- All inputs and outputs are buffered and suppressed for high noise immunity
- Wide range supply voltage input 15 ... 80 V
- 12 V and 5 V output for fan or external loads
Installation Manual (german)Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |
