Hotline: +49 (0)7227 994255-0
E-Mail: 
Indexable face milling cutter
Ø 60 mm Z3
For fast material removal on large areas, such as when leveling beams and boards. The use of indexable inserts makes this cutter a sustainable once-in-a-lifetime purchase. Each plate can be used on all four sides before it is finally worn out. Simply loosen the retaining screw with the tool provided, rotate the plate 90° and tighten the screw again. The cutter then is sharp like new again.
The box with ten replacement inserts that can be purchased as a spare part contains 40 cutting edges - seen in this way, an indexable insert milling cutter is not only extremely practical and durable, but also extremely inexpensive.
- Three-knife trimmer
- Diameter 60 mm
- Shank 12 mm
- Total length 70 mm
- max. PRM: 8000 U/min
- Indexable face milling cutter with three mounted cut inserts
- Allen key
- Square inserts 12 x 12 x 2.2 mm
- Attention: Do not confuse with plates 10.5 x 10.5 mm!
Manufacturer: | Responsible person: |
| Safety instructions: | ||
 | 1. | Always read and observe the safety instructions and warnings in the available documents. |
| 2. | The installation, commissioning and operation require special knowledge of machines and their proper operation, as well as basic knowledge of electrical engineering. The instructions - including those in the descriptions - must be followed carefully. | |
| 3. | The location where machines are operated must ensure that unauthorized persons - especially children - do not have access without adequate supervision. | |
| 4. | The use of kits / components usually requires additional measures and additions. | |
