Circular-Table with triple jaw chuck

With this round table, you can effortlessly engrave rings, thread milling, etc.
The  triple jaw chuck enables safe and accurate workpiece reception.
The reference switch can be used to define a zero point.
As a counter bearing, there is the tailstock RS102.

Technical details:

• Height of spindle: 32 mm
• Over all height: 55 mm
• Width: 42 mm (without shaft)
• With adjustable anti-backlash worm gear, gear reducation 54:1
• With half-step-mode = 21.600 Steps/Turn, 60 Steps/°, 1 Step = 1´ = 60"
• Circular accuracy: 0.01 mm
• Nema 17 stepper motor Nanotec with 1.8 A 1.8°
• Housing: Aluminum 7075
• All rotating parts are made of stainless steel
• With reference switch
• Horizontal or vertical assembly
• Fixing by M6 screws

Scope of delivery

• Complete rotary table incl. clamping nut and fixing screws for horizontal assembly
• Length of cable: 20 cm (on demand: longer with adequate plug for the 4th axis module)
• With half-step-mode = 21.600 Steps/Turn, 60 Steps/°, 1 Step = 1´ = 60"