Hotline: +49 (0)7227 994255-0
E-Mail: 
CNC USB controller Mk3 (9 axis)
| Support for Planet-CNC |
| Sorotec does not use any Plante-CNC products. Without our own experience, however, we lack the basis for competent advice. This is expressly not a rating! We do not sell products that we are not convinced of their quality. If you have any questions about the selection or troubleshooting, please contact the manufacturer directly (https://planet-cnc.com/). |
CNC motion controller is a link between personal computer and drivers for stepper motors. It uses USB or Ethernet port which is available on all modern computers and laptops. This is a complete (software/hardware) solution and it does NOT require any additional software (Mach3 is NOT needed).
The USB CNC controller is compatible with most step/dir drivers. It can be used as direct replacement for many parallel port break-out boards.
This controller is designed for Hobby and light industrial use.
Features and specifications:
- 9 axes controller for stepper and servo Motors
- USB and Ethernet Connection
- 110 kHz maximum step frequency
- 25 us pulse width, 50% duty cycle at higher frequencies
- 8 digital outputs on board
- 3 PWM capable outputs with selectable frequency (10Hz to 500kHz)
- 3 outputs with support for RC servo motors
- additional outputs with add on boards (currently up to 32)
- jogging keyboard support with speed potentiometer, shift, step and spindle sync feature
- 8 limit switches with shift feature
- 8 digital inputs on board, filtered and protected
- additional inputs with add on boards (currently up to 32)
- 4 analog inputs
- MPG pendant support
- spindle encoder and index signal support for spindle synchronization
- SD card support for running g-code without computer
- control external devices with I2C and UART protocol
Manual (english)Manufacturer: | Authorized representative for the EU: |
go to post