Power supply 12V 150 Watt 12,5 A Heng Fu

• Universal AC input / full range
• PF >0.98 at 115 VAC; >0.94 at 230 VAC
• Approvals: TÜV, CB, CE
• Protections: overload, overvoltage, overtemperature, short circuit
• Japanese brand components for key parts
• Electrolytic capacitors all 105 °C
• Dimensions: 212 x 99 x 50 mm

Specifications:

• Input Voltage: 85 ... 264 VAC (120 ...370 VDC)
• Input Current: 2.5 A
• Inrush Current: cold start, 20 A / 115 V, 40 A / 230 V
• Input Leakage Current: < 1 mA / 230 VAC
• Line Regulation (full load) ± 0.5%
• Voltage Adjust Range: ± 10%
• Output Overload Protection: 105 ... 150%, current limiting, auto recovery
• Output Over Voltage Protection: 115 ... 150%, shut off, repower on to recover
• Short Circuit Protection: current limiting, auto recovery
• Rise Time: 50 ms at full load (typical)
• Hold up Time: 20 ms at full load (typical)
• Operating Temperature -20 °C ... +70 °C (ref. derating curve)
• Storage Temperature: -20 °C ... + 85 °C
• Operating Humidity: 20% ... 93% RH (non condensing)
• Storage Humidity: 20% ... 95% RH (non condensing)
• MTBF >100,000 hours;
• Cooling: Convection
• EMC Standards: GB9254, EN55022 Class B EN55024, EN61000-3-2,3 EN61000-4-2,3,4,5,6,8,11
• Withstand Voltage: I/P -O/P: 3.0 kVAC / 1 min I/P - PE: 1.5 kVAC / 1 min O/P-PE: 0.5 kVAC / 1 min
• Vibration: 10 ... 150 Hz, 2 G 10 min / 1 cycle, 30 min each along X, Y, Z axes
• Mechanical Feature: enlosed
• Connection: 7P / 9.5 mm screw terminal block
• Dimensions: 212 x 99 x 50 mm (L x W x H)

1. All parameters are measured at 230 VAC input, rated load and 25 °C of ambient temperature.
2. Line regulation is measured from low line to high line at rated load..
3. Load regulation is measured from 0% to 100% of rated load for single output models. For multi-output models, it is measured from 20% to 100% of rated load, and other output at 60% rated load.
4. Ripple & noise are measured at 20MHz of bandwidth by using a 12” twisted pair-wire terminated with a 0.1 µF & 47 µF parallel capacitor.
5. The power supply is regarded as a component which will be installed into a final equipment. The final equipment must be re-confirmed that it still meets EMC directives.