Portal milling machine EMS-Möderl P2 0606
We will continue to manufacture the Möderl P2 & P3 machines for you in the usual EMS quality.
The P3 and the P2 differ in the future only by the fact that in the P2 only one spindle is installed in the table axis. As the table of the P2 is narrower, like the table of the P3, where two spindles run under the table. Otherwise everything is about the same!
The machines were equipped with driven nuts on the X and Y axis to achieve higher travel speeds with ballscrews.
Furthermore, the profile surfaces are milled in the region of the bearing surface of the linear guide rails to obtain a clean and precise stop edge of the guide rails.
The linear guide components, as well as the ball screw spindles incl. Nut come in the usual Sorotec quality from HIWIN.
The pictures show a fully assembled machine. The machine is delivered as a kit.
Of course it is also possible to get a finished machine from us.
Working area:
- X- Axis: 595 mm
- Y- Axis: 610 mm
- Z- Axis: 190 mm
- Clearance under Portal: 270 mm
- Clearance under Z-Axis: 255 mm
Profile:
- Table: 2 x 90 x 90 mm
- Table: Querprofile 45 x 90 mm
- Portalprofile: 160 x 80 mm
- Z- Axis: 20 mm Plate
Rails:
- Z- Axis: 2 x 30 mm rails with linear guides.
- X- Axis: 35 mm rails with long linear guides + 20 mm linear guides on top.
- Y- Axis: 25 mm rails with 4 linear guides.
Spindeln:
- Z- Axis: 16 x 05 HIWIN Ball-screw spindles
- X- Axis: 16 x 10 HIWIN Ball-screw spindles
- Y- Axis: 16 x 10 HIWIN Ball-screw spindles
Delivery time on request.
The stepper motors are not included in the kit.
This article can be delivered for logistical reasons only by freight carrier. Therefore, the products can not be purchased through our store.
Write to us. We will send you a customized offer incl. Transport costs.